Keywe lock Patch#

Patch for firmware defect in Schlage Connect, JFE109/BE469/BE468/BE468ZP/ BE469ZP/ FE469ZP which causes a loss of user details in lock/unlock notifications.

Keywe lock code#

Workaround for lock firmware bug in the FE599 and BE369 where it does not report the relock event after a user unlocks using a code.

Report if the user entered invalid codes through the ‘invalidCode’ attribute (fixed by lock at one report for every 4 attempts).

Enable/disable Lock n Leave (one touch locking).

Report alarms as motion sensors ( FE469/BE469/ BE469ZP) (optional, requires enabling in code).

Change user pin code length for Schlage Connect (468/ 469/109 series).

Configure the sensitivity of the Alarm for each mode (from Highest to Lowest in 5 steps) ( FE469/ BE469).

Configure the Local Alarm Mode on the lock (Off/Alert/Tamper/Forced Entry) ( FE469/ BE469).

Additional Z-Wave/Plus Lock Features (varies by model) For configuring the mode/sensitivity of the built in Schlage siren/alarm see this topic. invalid codes) and create custom actions/rules in CoRE/WebCoRE refer to this post. If you’re looking to capture specific events (e.g.

setSensitivity (“lowest”, “low”, “medium”, “high”, “highest”).

setAlarm (“off”, “alert”, “tamper”, “forced”).

List of available custom commands to use via CoRE/WebCoRE: It helps to add a buffering device/repeater within 20ft of your lock for best performance You can find the installation/update instructions here.

NOTE: Only features for supported/discovered features will be enabled (if it’s greyed out or says Unsupported, it means the lock doesn’t support the feature/isn’t responding to the discovery request). Pull down on the device page from the SmartThings mobile app to trigger a refresh and discover the locks capabilities and the supported tiles will be enabled.

Fix for pairing of some lock models causing loss of notifications.

Patch for firmware defects lock firmware which causes a loss of user details in lock/unlock notifications.

Handling of missing information while pairing locks.

Enhanced programming communication for a weak mesh.

Configure lock settings (device settings page).

Key features supported by DTH (depending on lock model)

Samsung Z-Wave/Plus locks (SHP-xxx, SHS-xxx).

IDLock Z-Wave/Plus locks (101/150) (door sensor).

Keywe lock pro#

August Pro Z-Wave/Plus locks (door sensor).Yale Z-Wave/Plus locks ( YRD256, YRL256, YRD240, YRD226, YRL226, YRD216, YRL216, YRD210, B1L, T1L, YRDxxx, YRLxxx, YRC2xx, Assa Abloy, Keyfree, Assure, Conexis, Touchscreen, Deadbolt, RealLiving, nexTouch, YDM7116) (DPS sensor).Recommend reading these posts about limitations of specific lock models Tested and verified and optimized on the following lock models:

Image 1847×527 47 KB Cheapest and best Z-Wave zwave locks